this was my very first print. I use it for a great many small tasks to hold things. great job with this versatile tool

this works with every application I have tried it with. thank you, great work

this is a great piece of engineering. thank you

I can’t say enough good things about this. I am very impressed and printed this multiple times to hold cans in the cabinet.

works as I would expect. thank you

works as expected.

created a good two tier filament AMS rack. unable to open the bottom AMS without removing it or the top AMS from the rack. I will probably print an extension for the bottom sides to fix this. This should not be construed as bad in any way, this is a great print!!

created what is shown. note to beginners, this uses a lot of filament with the P1S if you don’t change the color change purge options for filament.

works as expected. I did make a top for it too

attachments fit as I would expect. I will most likely need to use screws to mount as the weight of the attachments exceed the strength of the mounting tape. the design itself is strong enough to hold the attachments.

looks great. tail didn’t print. it broke part of the way through printing, even with supports. I chalk this up to my level of experience with 3d printing

looks great. I did manually modify the acorn top with a groove for the base to fit into, this secures it so the top doesn’t fall off

10 out of 10. love it. I use it for Tupperware

looks very nice and prints successfully. wish there was an easier method to join the two arts together. would love to have plates print this in more sections and make a larger skyline

works great. does what I would expect