I printed the trigangular supports in PETG and the clips in PLA. After adding these, my printer no longer wobbles with the AMS top mount.

No complaints and looks great.

My AMS hub is now completely straight which is what I was looking for.

I’m still a bit scared about picking up the printer with this. However, I can comment on the angle at which the filament is being fed and I think it’s great.

These clips look great and I have no complaints.

I know it’s displayed in the original photo, but I wish the surface was smoother.

I was a bit confused when it wasn’t secure. Then I realized that there are two little nubs that pop into place on the underside of the purge wiper. once I figured that out, I was very impressed and the second piece sliding into place also works better. the reason why there are “layer lines” on mine is because I used two different whites.