I love it! it was a super fun project in printed great! I changed a lot of the settings so that the crystal was much much clearer. It was hilarious (and very ironic) when I was printing this right before the print finished almost there was (And this is the first time this is ever happened) a power outage at my house 😅. We had our first power outage in a long time during the printing of the power Stone.

This was great! It printed gray and turned out awesome! I'm working on getting all the Infinity Stones. So excited!!!

I'm not finished yet. Here's what I have so far. For the top piece in the helmet I cut it in the slicer and printed in two separate parts so that there would be a whole lot less filament use for supports, I PLA welded them together. That's what the Frankenstein looking stitching is that you see on one of the pictures, it worked great! The faceplate took three attempts to print what I ended up doing was changing the height of the Z-hop on my 3D printer and also the support strength to strong, it worked great after that. I still can't get the eyepiece to print yet. I've tried three times already. Nonetheless, I love it anyway!

This is super awesome! NOGE FOR ANYONE WANTING TO PRINT THIS*** when you're printing the handle DO NOT PRINT IT WITH SUPPORTS I did, and sadly the supports broke halfway through the print (I think it was because my filament wasn't dry or something) The handle printed fine at least at first, but then because the supports were broken it was extruding filament into midair and it brought it on to the handle while it was printing and messed it up a little. When it finally got to the point where the supports would have been needed my printer printed it completely fine without them ;)

This works great.

One thing I would advise is printing the middle piece all one color if you only have one nozzle. Because it ends up using a lot of waste for just a tiny spot of red. You can always paint that on later. Also, it's gun hand broke when I was putting the gun in its hand :(

I love it!

Works great! It would be cool if you made it able to tilt though!

trouble printing

Nice!

The two colors kind of split.

I walked in my room and saw this. So cool!!!

:)