Simple and effective. Scaled it to fit my M4

Ansicht sehr cool, passt in der originalen Skalierung allerdings nicht.

Perfekt für töpfernde Tierfreunde

Passt so wie es soll

Sehr cool!

Genau wie beschrieben :)

Works just as intended and printed without a problem. The design is some of the best I have seen on here. Was a bit big for my bank card, but not a problem.

Works and prints very well!

Quick and easy solution for some Airflow and the PTFE tube doesn't rub against the glass anymore.

Very easy to print. Girlfriend loved it!

Benutze nur noch diese Spule, die kleinen Tunnel für das Filament sind genial!

Meine Mutter hat sich sehr über das Geschenk gefreut. Musste allerdings den Adapter hoch skalieren da er nicht gepasst hat.

Used this as a test for my Bambu PLA Basic Gradian. Looks really cool. Had to cut of a like a mm on the bottom as it wasn't completely flat.

Girlfriend loved it. Descriptions say you don't need supports, but you really should use them. They were a bit hard to get off in some places, but nothing too bad. I cut a bit from the bottom of the stand as the geometry made for a bad first couple of layers. I also printed it in two colours, which looks pretty neat.

Works great, was a big help!

Looks great! Print turned out pretty good. The Clip didn't work for me, as the strap for my medal was too thick. Tying a knot in the strap works just as well tho.

worked perfectly, she loved it

Passt gut und sieht gut aus

Funktioniert gut und lässt sich einfach drucken