Search models, users, collections, and posts
Bio
I started with 3D printing in 2018 with a MonoPrice Select Mini and quickly upgraded to an Ender 3. I tweaked the Ender for years: upgraded controller board, firmware, extruder, hotend, ABL (two kinds), etc. I learned a lot. I'm now printing with a Bambu Lab A1 (which I appreciate all the more because I recognize the superb attention to detail they put into it!)
All the CAD work I do is done in FreeCAD, which is my first and only exposure to 3d cad.
Most of the stuff I design has something to do with electronics projects and home improvement.
I finally got around to "fixing" the amount of reconfiguration required if you normally use a FlexShaft on your Dremel tool but also occasionally need to use the drill press. This adapter fits on the end of the flex shaft and just screws right into the drill press - takes seconds.
Dremel FlexShaft adapter for Dremel drill press
27
64
Share
0
0
0
No more data