Search models, users, collections, and posts
Bio
Love the tech and practical models.
Achievements
Pioneer Maker
Print successful 150 different models and 836 hours
MakerWorld Guardian
This badge has expired
Perfect base for the keychain with NFC. Thanks a lot!
Share
0
0
0
These are stunning! Had to print it at 150% scale as the original one is just fit for the smaller orchids, but both look perfect.
Plan on printing few more. They look and have lovely texture in PLA wood colors. Gives them “raw ceramic” feel.
For reference right one is the 100mm one, while the left one is scaled up 150%.
Share
0
0
0
Printed in ASA gray and it fits and works perfectly! Great design!
Share
0
0
0
Printed in ASA gray, fits and works perfectly!
Share
0
0
0
Looks and fits great. Happy that it perfectly fits the size of the door handle on X1C so it is possible to keep it on printer as reminder to use at all times.
Share
0
0
0
Printed in ASA, fits and works perfectly! Hard to even tell it is there.
Share
0
0
0
Printed in ASA and they fit and look like part of the printer out of box! Great!
Share
0
0
0
Share
0
0
0
After lot of search and trying out different ones, I am convinced this is the best model out there.
It has space for the aeration, fits the perfect amount of silica (not excessive), has thin walls but with longitudinal beams so unlike some other models wont break and spill beads everywhere.
Just perfect! Printed one for every single spool I have, so when vacuumed for storage (after proper drying) they stay dry until next use and ready for AMS. Which would not work with some other models where upon sealing it closes the only holes.
Share
0
0
0
Looks and works great!
Share
0
0
0
Profile is great as it prints rod in right orientation to keep the forces from breaking the rod. Original size (140% profile) works great for the larger buckets (5L and upwards), while the same model scaled to 50% works great for the smaller cans.
Printed dozen of them and intend on doing more.
Share
0
0
0
Just amazing, print turned out perfectly with PLA Basic for the frame and PLA Silk for the gears
Share
0
0
0
Love the idea and design, but these do not print well in ASA (for the UV and weather resistance given this is outdoors ovject), as tollerances are just not enough once the plastic cools down which makes them impossible to fit into each other.
Share
0
0
0
Look and work great, even for some things that are not round. Wife absolutely loves them.
Printed in red mate, and pink silky.
Share
0
0
0
Works as intended.
Share
0
0
0
On thin side, but works great!
Share
0
0
0
Strength Issue:In general, model is great, prints fast and snaps in spools perfectly.
However it lacks the structural strength (at least when printed in ASA to work for fillaments in the AMS HT). Maybe adding couple of support lines/rods along the height would help prevent it from snapping. In my print half of them broke when closing, and they do require a bit of force to close so lid snaps into place so it can’t open on its own when rolling in AMS. And the mesh couldn’t hold it.
I think with couple of support that would keep it more sturdy, it would easily be 5/5.
Share
0
0
0
Works perfectly, allowed me to connect both AMS v2 as well as AMS HT at the same time. Thanks a ton!
Share
0
0
0
A bit tight fit for the old MagSafe, but looks and works amazing.
Share
0
0
0
Perfect! Fits the 54mm Breville baskets perfectly! Nice touch on the details. Printed using PLA, and then washed the residual plastics with detergent.
Share
0
0
0