Search models, users, collections, and posts
Achievements
Pioneer Maker
Print successful 100 different models and 667 hours
MakerWorld Guardian
This badge has expired
Very good design. I rescaled it up, and no issues, except the brown one - due to low speed of printing (just 50%), some filling didn't join well and something is rattling inside. Orange (185% of the original size) printed on higher speed 124% and printed flawlessly. So just in case You want to print it on Your own - keep in mind, that slow printing speed may lead to failure of bonding inside supports.
Nevertheless I rate it 5/5!
Share
0
0
0
Both pieces fits very tight - no glue needed. Also fits tight enough on the straw. Very good design. I printed another cap, and the other one is too loose.
Share
0
0
0
Prints perfectly. And also fits perfectly in Skoda Fabia IV. Very good design.
Share
0
0
0
quality is better than I expected. I can recommend this design.
Share
0
0
0
I am super happy with this print. I can recommend
Share
0
0
0
Printed very well. But keep i mind, You cannot use it with AMS. it is very good clip for storing.
Share
0
0
0
Printed well, and i have no complains. Thanks for this project!
Share
0
0
0
Printed ok, but i had some issues with support removal. I broke some of these. Nevertheless, those ones, which survived support removal works great.
Share
0
0
0
I wanted to be able to monitor time (and tempereture by the way) on my electric scooter. That is why i ordered a cheap bicycle computer from aliexpress.
Electric scooter shows me my speed, so i didn't need speedometer. But i also didn't want to cut wire off 9or wrap it somewhere) the original mount bracket. There is a possibility i will use it later with bike. That is why i designed this mount bracket. I printed it with PETG.
Bicycle computer mount
4
3
Share
0
0
0
AS You can see on the picture, there are 2 minor issues - bolts are falling off the holes (fits ok, but there is too much room to the top of the box), and 2nd issue - spring don't fit 100% in the hole. Except that i have no complains and can recommend.
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Prints ok. But due to quite large openings, some dessicant can fall out of containers.
Share
0
0
0
Prints and fits ok. I cannot complain.
Share
0
0
0
Share
0
0
0
Perfect fitting, no complains. All types of filaments printed well.
Share
0
0
0
As You entered here, You probably have as issue with cats walking onto the top of the HT-RT3 system. Top buttons are touch buttons, and my cats sometimes can turn it off, or turn the volume up significantly. I do not use those buttons at all - my sound system is connected with TV via HDMI-CEC.
Sony HT-RT3 anticat top buttons cover
3
2
Share
0
0
0
Everything is ok. I recommend.
Share
0
0
0
As You can see, there is some dirt around, and this cap protects it from getting into the bearing.
Share
0
0
0