Already filled one and started a second! Fun print and love it.

Great idea and used a few times already.

Does what it says on the tin.

Clean and easy print.

Very happy with them and surprisingly easy to install.

Very easy to install and looks great.

Had one come loose but scaling up fixed the issue.

it's perfectly very happy with it.

Very fiddly to install but happy with the result.

Helps a lot with stopping the random scraps flying back.

Ran off a few plates in PLA and extremely happy with them.

Prints great but with the new 2025 Alex drawers there is a small gap on the left / right of the grid that allows it to move. If you have older drawers then youll get a snug fit.

Prints very well and is very helpful for reducing test prints.

Extremely happy with these swatches and will be running off a full set for my filament.

Extremely happy with only a few minor print issues down to my filament.

A little looser than I'd have liked but gives it the ability to move side to side. Much happier with the cable in this than attached to the PTFE tubes.

Couldn't be happier, will be printing a few more most likely for the small pieces that like to twist when cutting. Would recommend printing two sets of the dogs per bar.

Great fit and works a treat. Printed in PLA no issues.

Easy to follow instructions and very happy with the outcome. I did have to mirror the double meter part to make it all connect nicely so not sure if that was a mistake I made but very happy with it. Hopefully the humidity will drop for the filament over the next day or so to give a better idea how well it's working.

Printed great just got to make sure you read it properly!