I printed 2 of the 90 degree ones, they work great! Thank you for the great design.

This is such a great addition to this saw. It vastly improves the dust collection. For my saw, I had to do some minor sanding to make it fit. Thank you very much for your design time on this. It's great!

This is a really great print! much sturdier and better tolerances than the original piece. Thank you for sharing this.

Worked great. Thank you

This is a great tower design and a very good print. Out of the two version I preferred the look of the non embossed.

Turned out really well

This printed fast and it looks great. It's easy to read and very helpful. I didn't change a single setting.

I printed it in abs on a P1s it warped very slightly but it still works. I suggest if you use abs, use either a brim or some ears.

Great design, printed very well in ASA. The only down side is that is that it catches on the big tree after market build plates. It may work fine with others but that's the only one I have. If you pull the plate forward .5mm on the bed, everything works fine.

I printed the benchdog version. It turned out great. Instead of using clamps I just slip it over some UJk benchdogs. The fit was very snug, so I used the UJk reaming tool on it and it worked perfectly.. Thank you for sharing such a great design.

This basket prints very well. It comes with the brim turned on. I was able to print it with the brim of with no problem on the p1s. Thank you for the great design.