The top part was a touch too small to fit over the diffuser without some scraping/cutting. Apart from that looks fantastic.

Works well. It was a bit difficult to glue the two halfs together, had to stand it up on one end and sit a weight on the top for a few hours to keep the pressure on the glue. After that it was solid.

Easy to print and works well.

Printed well and a cool design. Unfortunately one of the pins snapped after about a week. Easy enough to reprint it though.

Printed fast and clean. Kids love them.

Printed nearly perfectly.

Printed out decent enough. A clever design.

I printed two out and both came out great.

Printed perfectly. Would go 5 stars if the hand and wrist were centered. I understand that it is a more reliable print this way though. Have an alternative use case to hold more than one set of headphones.

Good, quick to print model

Printed perfectly. Great model

Great model. Printed perfectly.

came out well. fit the fan perfectly

Printed perfectly!

Easy print.

it printed well but all my metal rulera had smaller holes.

Came out well. Supports under the belly came off a bit rough

Fantastic model. wish there were more versions & sizes of it!

Printed well. The little straw ring adapter is loose in the end of the nozzle otherwise a perfect print and fits well into my Dyson

Came out great. Kids love them. Printed with Bambu PLA.