it's a very beautiful box. it printed perfectly. the latches work surprisingly well.

great thanks

beautiful print. thanks a lot to the designer.

My wife said it works great! Thanks

pretty sweet print. thanks

scaled it up just a bit. printed with some cheap geeetech silk gold with 0.12 layer height and it came out great.

Wife is happy with it.

Fantastic model. I scaled it up as big as I could since it was just a little too small to accommodate the Kirkland wrap boxes which are 75mm. thank you

great print. slight issue with mine because the little bump inside the channel which should hold onto the hole in the frame was too large or something. I had to use a razor and cut part of it off. I'm not sure I really need to see the humidity inside my chamber but I had a couple extra hydrometers so I figure why not. thanks to the designer

Super cool model. The dial and bezel basically friction fit together perfectly. no need for glue or anything. I'm really impressed with the results.

I used these on my number pad. I like a pretty steep number pad and these were the perfect fit. Thank you!

love it

I used some capton tape over the edge of it so stuff didn't get stuck when scooping it out.

nice little box. fits a couple 18650s pretty well

fits my cen-tech calipers.

I used a little double sided tape on mine to keep them both sitting flat. works great.

i printed the one with bearings and it works so perfectly. spins with no resistance. super impressed by it.

this works great on my P1S. been using it for a couple weeks and have had zero issues.

these things are great. my favorite filament clips