Very good! Thank you for sharing.

Thank you for sharing. very useful. There was a little bit of play, so I used an O-ring to prevent it from rattling. Since no one else has pointed this out, I'm not sure if it's a problem with my printer. I used PETG.

This model is exactly what I needed. It printed well. Thank you.

There were some problems with the middle layer when printing with PETG, but the final result is not bad. I also enjoyed watching the printing process. I am very surprised that you can print like this with a 0.4mm nozzle. Thank you for sharing your wonderful modeling.

It printed well with PETG. Thank you.

Printed in PETG White. Fits very well. Thank you!

I printed it PETG white. Fit OK. Thank you.

Printed in PLA+ Black & Red. Fits very well. Thank you!

Printed in PETG White. Fits very well. Thank you!

It fits very well. Thank you.

The original was warped, so I printed it like this. Thank you!

Very good. I printed it at 80% scale.

PETG출력물 이상없고 Coobeen 스풀에도 정확히 장착됩니다. 감사히 잘쓸게요^^

Very good!