Prints great but it's too smooth. Needs some texture on the bit you put your thumbs on to turn it easier.

Fits batteries great. Very impressed.

Every kid in my daughter's class is getting a helicopter toy for Christmas.

Printed out great. Turns out I had green loaded in my AMS and it thought it was red. D'oh!

Prints great. Keeps the condensation drips off my mrs' coffee table.

Perfect for my kid's school bag. Feels sturdy but easy to open. Satisfying clunk when it locks.

About twice as big as the standard ones. Loads of lift. Very impressed.

These print great. I do them 2 at a time with autogenerated brim ears. I need a production line going though, they only last a couple of pulls before they go over the neighbour's garden.

Works great. Was initially skeptical when it didn't generate supports but is plenty strong and printed out great!

Nice small size for a kid to play like mommy and daddy. Seems like an awful lot of filament changes where it could just be a couple at each side.

Good print. Condensed the plates into just 2 rather than 16 or something. Came out great.

My little girl loves it for her "precious things"

Perfect print. Solved a problem. Tapered inside diameter means will fit multiple size nozzles 5*

Looks great. Not completely sure why it needs to change colour 11 times. Feels a bit wasteful. Why doesn't it just do the top layer or 2? Printed 2 to reduce waste. Only just fits on P1S bed. Was very tight fit when first put together but effectively sanded itself down against itself and now slides freely.