printed ok. I had to melt a screw into the clip part to hold it in place. Also be careful about leaving it in a warm vehicle if using PLA. an 8hr day sitting in the summer sun can make it a little soft.

printed well I PETG. time will tell how well it will hold.

Printed nice. I made a small modification that makes it easier to attach without fear of breaking it and uses the PTFE tube to help keep it in place. I’m not sure how tight it is compared to the original model, but the tube does not touch the glass lid. I do have a riser so that could be helping with the clearance.

printed nice although I removed the logo because I didn’t want the multi color.

printed nice. I noticed that the latches are slightly harder to close than open. I like that it uses no extra hardware. Be careful about tipping it sideways if you have something thin like M2 washers stored inside. The lid does not perfectly seal against the dividers. Maybe consider adding a small lip in the lid that goes inside of each dividers.

they stack nicely in the small container.

Assembled with out difficulty, although the hinges seem very fragile.

fits nicely. It could be removed with a small screw driver if needed.

very nice compact holder. it would be to have a lid that friction fits on.

worked ok. I had to round the corners to make it fit in a different model.

very useful clamp. make sure you set the number of perimeters on the frame high enough (minimum 3 or 4). I added a small loop to mine do another project.

printed well. the small lid is nice.

nice little container.

printed nice, but the holes are so short that the ptfe tube won’t stay in place.

very useful. Now I don’t have to disconnect my AMS to use the external spool.

printed great. I did decrease the infill percentage by 10% because the holes seemed a bit small.

printed nice. WARNING: DO NOT MAP THE YELLOW FILAMENT TO THE SLOT WITH THE ORANGE FILAMENT. I wouldn’t recommend mapping the white to that slot either. I did that and ended up having to do a manually timed swap, which caused all sorts of issues. Bambu studio would not let me reload the yellow so I had to bypass the AMS(see pictures).

Printed nice. Fits perfectly.