Printed nicely

Looks great. The feet are very thin though and easily broke.

This looks amazing. The only complaint I have is the top has a pretty loose fit with the keypads I am using so the head pops off very easily.

This turned out pretty good. I used a fresh 0.2 nozzle and overall it came out. The only issue is the fishing rod on the back is very lightly attached so it moves back and forth and I suspect will fall off shortly.

I printed with 0.4 and it turned out pretty nice but I can see the advantage of a 0.2 with this print.

It printed fine but getting the paw pads to get seated into the keys so it freely and easily clicks was definitely a bit challenging.

These work great!

This looks way better in person. I am not sure what black magic is involved but when I take a picture of it the layers are defined very strongly.

I scaled this up quite a bit and printed a custom little plaque (58mmx35mm w/4mm Chamfer). Worked great.

The head screws on nice and tight.

It was a bit tricky snapping both sides together. I am not sure I am going to be able to replace the blade but let me just say... It does in fact cut like butter. This works fantastic.

This works fantastic! Melody is very clear.

Works great! Clear sound. I only wish I instead of RR it said something else like Zelda so you could properly rick roll with it :)

This works great but just a heads up for folks the center parts of the top piece circles will most likely break off at least if you slice with Bambu Studio 2.x. When you look at the slice there is a small gap and it just isn't enough to keep it from breaking out. I even tried adding brims. Either way, don't worry it works perfectly fine even as one big opening and you can't really even notice.

Fantastic

Worked Great

Printed fantastic