I had only completed a few prints before I realized how a turntable would make my life easier. Found this design and decided to print it, without the backdrop holders, and it went great. The only issue I ran into is that the 3D printed screw that holds the handle onto the handle rod had some trouble, not sure if I maybe cross-threaded it or what, but I was unable to get it fully seated. I was also using a smaller screwdriver, so I kind of stripped the head of the screw slightly. However, it still works great, I won't deduct a star for that, especially as it very well could have been my fault. Happy with this print, and I have already used it to take pictures of a handful of my prints (I attached a couple of gifs of it in action).

I have ordered some primer so that I can paint this design, but still this is such a cute and fun little articulated squid. Print was simple and feels great with movement. I was very nervous about removing the tentacles from the Cool Plate SuperTack, but everything was fine, I just was careful while removing it. Love the design, can't wait to get it painted.

Honestly I was just looking for some cool fun things to print and I came across this design. Print went well, supports were good and not too difficult to remove, overall looks good. The only Support issue I have is a little bit of support left behind on the upper part of his jacket, I need a tool to remove that piece. Other than that, I think this might work better with a base under the feet, because the design is a tiny bit heavier in the back, so it is not the most stable, you can see in my image how the front of the feet aren't touching, that is because it is leaning back slightly. But the figure still stands, so that is why I only deducted 1 star, I wish I could give this 4.5 star rating.

Was excited to try this print and I don't have an AMS yet. Decided to use my son's band and their album as my test. Was an easy print, even for a newcomer to 3D printing such as myself. The reels and spotify code base were hard to get into the cassette frame for me, but my daughter with smaller fingers got them in place pretty easily. The middle piece is not fit snug, but I believe that is the design. For my printing need, I would actually like it to fit similar to the other pieces, I don't have a need to swap it out, would be nice to get instructions on how much bigger I should make that pieces so that it sticks in without me needing to glue it. Also, if I could do it again, I would reduce the depth of the text on that middle piece. The Spotify code took me a minute to figure out, but just because I am new to all of this. Had to go find the base and Spotify instructions in the original design that this was remixed from.

Such a nice simple print that serves a purpose. Even from my phone I was able to print up to 10 clips, or in my case I selected to print just 4 clips, was very easy to do.

fun little print, looks great. my son will test it out later tonight and see how it works. I used PLA basic, so we will see, might need to use a different filament to give it some flex. taking pictures of this print was difficult though.

love the design, not much poop produced from my prints yet, so this will work great. printed great and quickly.

Such a cool design, I still need to paint this model but really happy with the results. This was only my second 3D print job and it went really well. Would love to see more of the Bob's Burgers characters available from this creator. I saw somebody else mention that Tina is missing an eyebrow in this model, I can confirm that is a fact, but doesn't detract for me. I can paint one on or I assume once I learn Bambu Studio I could have added one in there.

I just purchased my first 3D printer and completed my first print. Amazing how much enjoyment I got from watching this cute little benchy boat materialize before my eyes.