Wanted to test out a small flat picture type print, thought this would be a good test. Print went well, thanks for the design. 

fatsarmstrong

LuckyMountainMan

Alianza Ace

Alliance Ace

0.08mm layer, 2 walls, 100% infill

Fun little print, been playing with it today. I am on an A1 mini but I selected the 20 triangle version, so I scaled it down a bit to fit my plate. I used PLA Basic and the SuperTack Cool Plate, wasn't too hard to remove after the print completed. I had to work the articulating joints a bit to loosen them up, but works really well. 

Folding Triangle Fidget Chain V2

20 Triangles

Was looking for something related to gymnastics that I could print and maybe even send out with my daughter's graduation announcements this year, this turned out great. This was just a test, that is why it is just in Black PLA, I ordered some multi-color filament specifically to print more of these out. I mentioned in a comment, but the only issue I had is that the slicer displayed an error about "floating regions", but I just enabled support or whatever the error suggested and then everything went smoothly. 

Note: I printed on an A1 mini with the Cool SuperTack plate and PLA Basic filament. 

matthewsmessmakers

Gymnast Flexi Keychain or Decoration V1

0.2mm layer, 2 walls, 15% infill

Nice simple model of a claw foot bath tub. I was looking for something I could put some little ducks into for a home decor piece and this looks perfect. I scaled the model up to take up more of the print plate on my A1 mini. I only quickly pulled off the supports this morning, I didn't sand or add primer or anything, so these images are pretty raw and I think they still look great. Once I get it cleaned up a bit and size-tested with the ducks, I might print off one or two more. 