beautiful, I printed 5 of them in white because the girls I gave them to will color them as they like

Great model, I printed it for my mom's tablet and she loved it! Perhaps it would have been better to round the inside of the hooks where the tablet fits. I rounded them with a utility knife because I was worried they might scratch the tablet over time. Unfortunately, I was unlucky and a support came off, but I managed to repair it, and the detachment of the support didn't affect the aesthetics of the front case.

perfect! thank you but I preferred to use the layer height at 0.12

good! thank you!

I love it! ♥️

good!

It's wonderful, I printed it as a gift box! However, I had to activate support on the holes in the ribbons, otherwise with the PLA silk they didn't turn out well and the part between the holes broke. Unfortunately, this happened to me twice, I've attached a photo 😢

perfect

simple and functional, excellent!

Nice model, but it's a bit difficult to insert the charging base, but the cable is perfect. I managed to insert the base, but I'll have to break the model if I want to remove it in the future. 😅 Printed in PLA with my A1. I have a Xiaomi Watch S4, but the base is the same as the S2.

Perfect! I just modified the magnet inserts for my 5x2mm ones.

Fantastic! Thank you so much! ♥️

Very cute!!! For the hood, I used the profile for the white Kaihl, or in my case, the blue ones. However, I used glue on the hood otherwise it would come off.

Excellent, it also works well with the blue Kaihl. However, I used glue on the cap otherwise it would come off and lowered the layer to 0.16 like the designer's base.

Customizable to your liking, I love it. I made a test one for my small kitchen, but I also tried it on my desk and it looks great. Now I'm stocking up on filament and reorganizing my desk! Thanks!!!

Very useful for storing my four buildplates. Unfortunately, they can't be joined easily. I tried pushing them together, but they stuck, so I used a hammer to push them in... 😂 (I protected the printed part from the hammer blows with a microfiber cloth folded in 4).

printed in petg! I love it! I will print the other versions too

adorabile!