Search models, users, collections, and posts
Bio
FDM-obsessed dad trying to support my habit by promoting artists. I am passionate about the 3D printing community and enjoy sharing my creations and supporting talented makers.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Stellar Reviewer
Rate or Comment 227 different models
Pioneer Maker
Print successful 183 different models and 3,717 hours
Share
0
0
0
Tried the .4, the .8 and the .6. Point 6 is the best imo.
Share
0
0
0
The horns didn't print well, didn't have time to play around with it.
Share
0
0
0
Wonderful dragon! articulation is fantastic. Love the horizontal joint on the rear legs - lets them droop without being floppy. I'd love to see the wrists articulated in this limited way too.
One note: printed this twice now (the reduced size model both times) and both times there was poor movement between the hips and the body section behind them. this was caused by some pretty robust stringing that needed some attention, but not enough for a star off.
PLA Red Matte and Generic PLA Gold Silk
Share
0
0
0
No more data