this cross came out really clean, really nice & it's very lightweight! I printed it in gold silk PLA & my mom couldn't wait to hang it from the handle of her tumbler 🥰 thank you for this print!

super cute! I printed one in white & one in green then mix matched them. added a little Easter grass & some Reesies eggs for my nephew's teacher & she loved it! my only complaints: the little post that good through the handles & holds the flower petals is too big around for the ring that secures it, yet too short to hold both petals, only allowing for one petal on one side when two are printed. I was able to bore the inside of the rings out with a file enough to push it through, but it was still tough to do.

I've printed 3 of these spools so far, they've all printed perfectly & work exactly as intended! I also appreciate the little slot for the filament end to slide in to keeping it from creasing. thanks for this design & file!

these eggs are beautiful! I'm still new to this world, so I was trying to snip the bottom support off, but found it was much easier & cleaner to just put a little downward pressure with my thumb & peel. I was honestly a little sad to see them go bc even the supports were pretty, lol! my only issue is I can't get the designs to line up when putting the bottom caps on, but they do screw on nice & tight! printed on Bambu P2S in PLA Silk Dawn Radiance.

printed this adorable little guy in PLA Silk, Dawn Radiance on our P2S. I do wish the top was smooth, but I'm not sure if the printer can even do that since I'm a newbie, lol. thanks for sharing this design!

great sturdy little stands for the thin "He Is Risen" Easter bunny!

these are beautiful!!! I printed one in green & one in gold silk. the stands are a solid & perfect fit!

this poop slide was larger than I thought it would be, but it was only my 3rd ever print & it printed flawlessly! it also looks very nice perfectly snugged against our P2S. great print! thank you!

love these!