printed in panchromatic white PLA, awesome outcome.

printed no problems, I don't know why I can't insert a logo. or there's someone can guide me just a though. So I printed logo on another plate and just glued it.:) thank you for a great file

My Godson likes so much. Thank you

problem for me when I printed out the numbering for my switch is not the same order as the print. mine is 1,3,5,7,9, thank you

great organizer for my braun, 1 little quirk the largest assessor trim won't fit but the others fits perfectly. thank you

really awesome print, but can you check why the words from both case and cover upside down? when you assembled close, thank you

thank you, printed the original and printed a 3 whole (cut and merge)

a bit loose, tried sizing it to 92% to tighten the grip of the cable but not so tight, thank you

printed again for my packet bins, found out that the original size fits perfectly for the not label Milwaukee bins that came from the packouts, but for the label Milwaukee packout that you bought separately need to adjust the size less 2mm cause its loose. thank you

lovely for my Ferrero, friends love it, thank you

fits perfectly, printed, thank you

fits very well, prined a lot for my project, even merge it to more cables to fit around 10 holes. thank you

this is my 2nd print for additional build plate holder thanks

awesome print, for my nephews birthday gift, but I really like to enlarge the full print capacity but I haven't tried it yet. thanks

used on my project, but I have some ports that can came out without the key. probably port issue or rj45 problem. thank you fir the file

absolutely great print