Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Stellar Reviewer
Rate or Comment 202 different models
Pioneer Maker
Print successful 177 different models and 1,546 hours
Turned out good. Made installing my side mounted filament holder a success. Just dont over tighten the connectors.
Share
0
0
0
Turned out good. Way more convenient to put the filament on the side. but why doesn't the inlet face the roll of filament? Seems plenty strong enough to hold up also.
Share
0
0
0
They turned out great. Print really fast and dont use much material. You can see the dust that accumulated after just a week. I'm glad that I did these up right away.
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Turned out really good. Easy and fast. My only concern is, does the top lid ajar, with this, allow enough air flow when printing PLA and PETG without it getting too hot inside the enclosure?
Share
0
0
0
hard to push the 2 small buttons. . but other than that, turned our really good.
Share
0
0
0
I printed plate 2, but the 6mm magnets were too tight. no big deal... I also used PETG for mine. the bottom layer could have used more layers. but no big deal there either.. they feel really durable, time will tell. they will sure be handy in the garage. thanks for the great file
Share
0
0
0
No more data