All turned out great. In my wife's office now

was a fun print and build

Love it, would not have expected the green color from spool to this.

The best one I have built to date. Great design and profile. I hope creator will take up on my suggestions for future firmware and some design upgrades. For those who to snip at the cost, think about all this effort that went into this, countless hours of trial and test prints. This is well worth the investment. I made mine out of PETG, Bambu Translucent Gray, Inland Translucent Orange, Ranki Translucent Yellow.

Printed great but I may just reprint my old ones as the light is directed more downward. These have an angle and projects into the room more than my previous ones did. I like the design and maybe change this so the angle does not create a glare.

Printed great and very nice but it wasn't for me because I do not have the light and camera extended out. I didn't realize this until after I printed it.

System works great. Uses a lot of filament. I made over 100 of these across 4 printers printing non stop for days.

Works great and love it, much better than what I had before. I just had to make 20mm additions to the bottom to accommodate the sliding drawer. I would suggest designer just increase the height 20mm at the bottom for better clearance for the drawer to slide out better.

what a great print

What an awesome print this was. I like that its 2d - 3d printed. Nice texture to it

so far so good, works, I printed in PETG

works as it was intended for, nice job

I would like to see more like this. I like the 3d but the softness gives it that nice touch.

Love it, this has depth

works, takes up the slack of the width especially with Inland spools to use in Bambu spools

A great idea with organizing all the cell batteries. A little tight on the lids when closing near the end. My work around was razor blade off the tiny nub and little flat sanding on back side of lid. If it matters I printed this with Inland Silver PETG and may be why tolerance is tighter with calibrated filament.

was perfect for my wife's needs to declutter the battery drawer

All part printed very nice and clean, waiting on electronics to fully assemble

Great clean print, next to do some rub and buff

did the job