#PrintClinic #Printing Issue #Questions #Needhelp So I have the Anycubic Kobra 3 my friend bought it for me and when he bought it the owner said it had problems that needing fixed liked the axis bar being bent and I had that fixed by a mechanic that straightened the bar out so I fixed that problem then I ran into another problem the hotend covered itself in filament I changed it and it did again after a few prints so after like two times replacing it my printer decided to go into my build plate ruining my rainbow build plate on the one side and my regular build plate on the one side I can use my regular build plate on the other side because i caught it before it dug in worse so then I replaced the hotend again and then i printed a pole for a spool holder and it printed most of it until like at the last 14 layers out of 134 layers and when I seen the print I stopped it because at that layer the printer stopped printing on the actual print and started printing off of the print so I researched and figured out to replace the nozzle sock and the nozzle and the I replaced the whole extruder part and at first the filament wouldn't go through so I took it off and put it back on because there was nothing wrong with it and then the filament would come out but now i ran into another problem the printer isn't pulling the filament like it's supposed to and if i push it in it will work because I'm pushing it i will post pictures in a second just someone please help me. This is a video of me showing how it isnt pulling filament itself(Edited)