Search models, users, collections, and posts
Bio
Electronics engineer trying to figure out CAD
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Stellar Reviewer
Rate or Comment 423 different models
Pioneer Maker
Print successful 389 different models and 1,821 hours
Very cool design. Came out nicely in JAYO matte grey PLA.
Share
0
0
0
One of my favorite designs
Share
0
0
0
Beautiful design. Printed in high speed PETG. I might try some smaller layer heights for added detail.
Share
0
0
0
Awesome design. Printed in PETG with some pillowing on the slanted surfaces. I will print again with more walls to compensate.
Share
0
0
0
Share
0
0
0
Printed nicely in JAYO matte black PETG on the X1C and JAYO matte black PLA on the A1 mini. Thanks!
Share
0
0
0
Share
0
0
0
Printed with JAYO matte black PETG on the X1C. This design saved me when I needed an instant fix for my broken glue gun trigger. The print didn't look very clean and I have my doubts about the chosen orientation but with some post-processing it works perfectly. Thanks for sharing!
Share
0
0
0
Printed well with generic yellow ABS and a pre-heated chamber on the X1C. Thanks for sharing!
Share
0
0
0
Printed nicely with Bambu Labs ABS in black on the X1C with pre-heated chamber to prevent warping. Very cool model that fits well even with the ABS shrinkage. Thanks!
Share
0
0
0
Very handy! Printed nicely with JAYO matte black PLA on the A1 mini. Thanks!
Share
0
0
0
Very cool. Printed nicely in JAYO matte black PLA.
Share
0
0
0
Really nicely made and a very cool idea. Printed nicely on the A1 mini with white JAYO matte PLA. Thanks for sharing!
Share
0
0
0
Printed very nicely with JAYO PETG on the X1C with BIQU Cryogrip Glacier build plate. Although the rotating grippers were fused in place it still works. Thanks for sharing.
Share
1
0
0
Printed very nicely in ESUN PLA on the X1C and a BIQU Cryogrip Glacier build plate. Thanks for sharing!
Share
0
0
0
Printed in PETG on the X1C and two ball bearings didn't print correctly. I'll retry using PLA.
Share
0
0
0
Share
0
0
0
Really cool print but I did have a repeatable defect near the top, not quite sure what happened. I still love it though. Thanks for sharing!
Share
0
0
0
The post is no longer available
An amazing design that works very well with my Honor Magicpad 2. Printed in ASA on the X1C with a pre-heated chamber. Slight warping but it fit well nonetheless. Thanks for sharing!
Share
0
0
0