I'm absolutely happy with how this turned out! I learned my lesson on the first attempt at the board when I discovered (the next morning) that I put two magnets in wrong. After printing a magnet tool and getting it right the second time, I'd say it turned out pretty good! The only minor gripe I have is with the lids. On my board, the lids are a little too tight, so when I close it and lock them there's some rubbing against the board. I'm not sure how I can loosen them up on my own to make them fit just a tad bit looser. Aside from that, everything else was great! Printed in Bambu PLA Wood Walnut and Oak.