Fits perfectly on 75mm diameter tin can as described, enough grip that it doesn't get knocked off but not too much to make hard for removal. Printed in generic TPU on A1, took approx 1 hour.

printed this to replace a resin dispenser (which is heavy enough to damage porcelain sinks). The top surface has visible lines, suspect it needs ironing and perhaps further adjustment. Would also like it if this design was 2 or 3cm taller so I don't have to cut a pump tube to size!

printed very well, adjusted the wedges down in size for the 2 piece variant and used super glue and accelerator to connect them. Fit my SMT1000 well and clocks in place without too much resistance

Printed really clean and works well with the XL Kong, absolutely no problems and does what is required.

brilliant and very easy to use, will likely print a couple more of these in future!

Nice and quick print, perfect fit on was charger