Thank you for that remix! It´s massive and looks absolutely stunning! Used Rosewood PLA for the stand and PLA silk silver for the warsun. The plaque is also PLA silk with a PLA Metal gray top layer. For the shiny surface make sure you slow down the outer layer speed to 30mm/s. Make sure the outer layer speed is consistent throughout the print to get a consistent color.

Looks really good! Had some issues with pla silk, but these were on me and not because of the profile.

looks amazing! 80mm (diameter) version has a height of 10cm

Great design! When putting in the magnets I would recommend adding a drop of super glue. Not sure if its because of the pla matte black filament I used but I noticed that the magnets would often slip out again after a few tries if I don't use glue in addition. It just takes a very little drop though. For a board for up to 6 players you need 37 tiles 222 magnets 666gr filament On an A1 I was able to print 4 at a time in 1h50min For the 8 player board you would need 61 tiles.

works great!

looks good!

Looks really good in matte black!

Looks and feels really great! Benchy for scale.

Fits perfectly!

Mono color profile without logo came out great! Benchy for scale. Thanks for the design!

Great design! When putting in the magnets I would recommend adding a drop of super glue. Not sure if its because of the pla matte black filament I used but I noticed that the magnets would often slip out again after a few tries if I don't use glue in addition. It just takes a very little drop though. For a board for up to 6 players you need 37 tiles 222 magnets 666gr filament On an A1 I was able to print 4 at a time in 1h50min For the 8 player board you would need 61 tiles.

Looks really good! Benchy for scale

great print, great look! looks really nice in matte pla black