Dieser Mobiltelefon Stand ist echt genial! Er ist viel stabiler als das alte, welches ich mir mal gekauft hatte. Mein Mobiltelefon ist ein schwereres Modell und es steht da drauf wie eine 1, nichts wackelt mehr, es fällt nicht um. Aber da ich es für meinen Partner gedruckt hatte, musste ich es erst mal wieder abgeben 😅 Bedeutet ich werde mir auf jeden Fall noch eins für mich selbst ausdrucken! Die große Wurm schraube habe ich im Stand gedruckt, aber einzeln, im langsamen Modus. Dadurch hat es zwar länger gedauert, jedoch ist es ohne große Stützen etc ausgekommen. Was ich mir noch wünschen würde: Verschiedene Designs bei der Ablage Platte, wo das Mobiltelefon drauf liegt. Da könnte man so was wie Sterne oder Monstera Blätter oder aber auch einen Gaming Controller als Design nehmen. Denke so kann jeder sich aussuchen was er/sie haben mag 😊 Hab es in PETG gedruckt, mit meinem eigenen, angepassten Profil.

A very nice model, which the creator is still working hard on, even if it takes a while. It can be printed support-free with PETG, I have tried it out. I like the design, the size is okay, but I would like the larger version advertised (better for thick-stemmed plants like Monstera), i.e. an XL version. Perhaps a smaller one wouldn't be wrong either, or a half-round one with the great adjustment screw for self-watering instead. However, it should then stick out a little more.

I only printed the foot, which was as big as specified, but I will probably only use this model much later, which is why it will only be the foot for the time being. But it printed perfectly without any support, I was also tempted to try printing something bigger than usual in my Bambu Lab P1S. =) - It is currently the umpteenth semi-circular model I have seen in this size. Chapeu, many thanks for that! I would be very pleased to see an adjustment screw for your models, for self-watering.

I really like this semicircular moss stick because it looks chic, is still supported and is easy to print. There are also two size variants, with two round feet (great for mineral substrate), so smaller pots have also been considered for starters. A drip irrigation system has also been thought of, although I don't have an adjustment screw, apart from that you get a super all-round package here, where the creator has really put some thought into it.

This is a good cutting holder, it prints very well (the Monstera leaf version). Perhaps it would be nice to have some kind of entrance/slot so that the aerial roots of the Monstera plant are not crushed.

Hello, this is the first time I have printed this self-watering system correctly. The previous time something went wrong shortly before the end and it came loose from the printing board, which resulted in filament salad. Now everything went smoothly and it looks quite good so far. I also printed out the required M3 screw with a length of 10 mm, so the rust problem mentioned in the description has disappeared. However, water is also coming out of the PETG seams. I dunno why