saw on reddit, printed immediately, much satisfying. the fuzzy skin caught me off guard when I pulled it off the plate, but I don't mind it. Gonna go print the triangle now, thanks!

Super cool! I made a sort of poor man's "Burnt Titanium" filament! There wasn't quite enough filament to finish the print, but I'm happy with it as a proof of concept. It would be cool if you could make combos to test them and then go someplace to custom order a kilogram of personalized multicolor filament. I included the swatches I have in the photos. The third color not in the photos with the swatches is Bambu Iriduim Gold PLA Metal. I did purple on the bottom if it helps c: Thanks!

inland high speed pla+ olive green bamboo pla metal iridium gold

printed in ABS Useful, quick, easy, and barely uses any filament. What more do you need in a print? 10/10

Thanks!

made 2 and one's mechanism is significantly smoother and cycles constantly without jamming. the other... looks nice.

Fantastic!! Installed on an X1C and printed in Polylite ASA. I had to slightly sand the "middle peninsula" (part at the front middle when installed) to make it fit within the chute, but it was only slightly too long. After that I tested it with a filament change and it seems to be working really nicely. I wish the newer comments showed up first by default. I almost went with another model after reading some of the comments complaining about issues with earlier versions.

Printed great. I freed it up by spinning it with a little force bc it was lightly fused in place from the build plate. Then I just added a touch of grease to the gears. Spins smooth and looks fantastic! (printed in marble PLA)