The print is wickedly amazing. The fidget works great. It was a little bit of a challenge at the beginning to get it broken and moveing. I had to use my pallet tool to fit between it and kinda get it started, but once that was done, I love this thing is awesome!

printed great, was not sure if it was suppose to print without supports, so I used some tree supports. very little was needed. going to slap some paint on and get it in a campaign at some point.

Printed amazing with tree supports everything came out very well. I ended up using a .4 nozzle instead of a .2 but the layer lines look like it’s a part of the miniature and looks great. I’m thoroughly impressed with the mini.

printed amazing and works like a charm. I call it hand of fate. a reroll of the dice 🎲

Printed great and looks awesome. will hold a pen or paint brush. Wish the arms was a little more out. May have challenges with larger barrel pens. But still looks great and the two tone gold/red looks awesome on it make the details pop.

Printed great and easy, no supports and just a little bit of filament. be a great print for when running low or purging the last of your filament. looks great with Mounment Hobby brushes. now to get it nestle in my paint table.

was a great print. thanks for sharing, planning to use it with my air brush for priming. I added 10x1 magnets with glue. would be great to have that sunken in for it. There could be some ergonomics help with the handel, and the trigger could use a little strengthening.

Printed beautifully!! Love the design. printed small then I expected, will fit small single to couple of flowers or couple of pens. I am going to scale up and use it for a minature paint brush holder. printed in dual gold and red filament.

printed grate and looks awesome. tree supports where we'll placed and came off easy. readying to prime speed paint it and get it into my games.

printed great and looks great. I used the improved the tree supports no flaws.