I had similar stringing and general quality issues to others that have printed these. More a problem with the filament, filament settings, and friendliness of slicer settings with TPU, instead of the model maker. Otherwise great model👍

tolerances:🤌🤌🤌💯💯💯 glue needed in assembly: 🙅 model: 1000/10

Assembly took a little more effort than I expected. The chamfers on the arms and stand could be made larger and the threads were a little tight. Otherwise fantastic model, keep up the good work 👍👍

I adjusted the model and removed the raised design on the top, which made it flat on the bottom and top of the print. Design is good and made for an excellent Christmas gift

assembly instructions are a bit misleading on where to put the lock piece, otherwise fantastic model, will print again.

perfect print

made for an excellent Christmas gift 👍

got rid of most* of the stringing and issues that the default settings fall short of. I had very minimal warping and print quality was pretty consistent between jobs. My only complaint is the quality falls off a bit with the seams, but this is most likely due to the high retraction length setting.

excellent and satisfying surface texture, also printed very nicely, just needed to move the joints back and forth a few times to loosen them up after the print

ADHD brain go brrrrrrr

What psycho would rate a benchy less than 5 stars?

can't be any simpler, print the model, install on printer. No hassles whatsoever

I get a sharper and brighter tone out of these compared to my regular ceramic picks

very nice Post-it organizer. But the stencils aren't basic ballpoint pen friendly, and the thin sections on the "S" letters in the calendar stencil broke after light use (about 10 uses). Most likely user error though.

excellent clamping force, but definitely print in PETG. Much better friction and strength compared to PLA (I printed in PLA)

look mom, no hardware!

short ones work very nicely, but the longer ones can unclip by themselves because they can bend easier

excellent

prints well but some of the zipties don't work well

Fly's better than a really well made paper airplane