Great thing. Works and stand! Thank you.

Great design. Maby a little hole in the bottom and a small plate would be greate for watering.

Is a working part, but for me is too big.

I was new to 3D printing and didn’t knew there could be “poop” from Printer. But this addition really a great thing. Now I can easily gather it.

Huge and most useful upgrade to my AMS.

A great upgrade to my AMS. Now I can use reusable desiccant without any problems and not afraid to spill it all over my AMS.

Works great and gives a feeling of a good mouse. I would it even compare with my MX Master 3S

Not used yet, but it looks great.

Cool thing. Unfortunately I realized only after printing, I need a rubber band, but I found one.

Super boat. Now I have a nice thing in my room!

Great work. The mous have fast the same filling as my Logitech MX Master 3S. Greant thing.

Worked perfectly. Was a little confused about the small part where to put it, but after a while found a spot and how to place it. cannot wait to use it with my AMS. Thanks again.

Very interesting project with a lot of ingenuity and DIY parts. With a small adjustment of the color layer printing one of the parts becomes unnecessary. The description of the installation of the software on the microcontroller is missing some steps. One suggestion for improvement is to replace the USB-C power supply with ordinary batteries, so that the clock can work independently of the power supply.