So my battery bank ended up being to heavy but still fit. Right now it's just sitting there, but will eventually put something on it to balance it. Keep in mind if you have a wheel dial as an adjustment, you can still use it but if it has a button on the middle it's a bit awkward to get to. Easily still worth it though

love the look and my wife is happy everything is put away. I will say if you have a heavier strap, the camera protection isn't as good. I'm going a little block at the end to make sure the cameras are blocked. Still love it though.

Printed very well, I would be careful removing from the plate though. One tiny piece broke off so currently put some heat resistant epoxy to fill up the hole. Can't wait till I can put in my AMS.

Printed well, a bit pain to get supports but not too bad. Make sure to measure your containers first as mine did not fit :( . However that is on me not the print.

Printed very well and snapped together. Works very well and makes it look so much better.

printed well I had a bit of warp but should be fine. My printer tends to wrap a bit though. Working to eventually use as a like a duct inlet fan.

overall printed well, ended up going for dark green and brown. Finishing the base soon

I have a custom set up so had to stick some cardboard and longer screws to line up but it prints great and helped a lot

Prints very easily and love the tile system

exactly what I needed and printed very well

was a perfect replacement for my webcam! thanks

printer cleanly and got to use it once so far without any issues.

Overall printed super well, if you are using plain paper a standard double fold was not enough grip for me. I ended up folding it again at the bottom so it was like a quad fold. Then it was strong enough to grab by the paper.

support came off cleanly, printed it in two different colors to show enemies and friendlies better.

I have my printer in a stacked Ikea lack with a brace so I was worried about the fit. Not only did this print smoothly it fits perfectly.

Printed very well for effects plate! wanted something so the name has the effect, so needed to be flat. Had 0 issues and my wife loves it. Now a bunch of people want them in my office. printed in esun pla+ black and esun pla silk magic green with Galaxy plate.

So far so good, printed two and will update once I have time to get the others. However did a dry for and seems very sturdy. Love I did not have to measure anything.

Overall works as advertised and super easy to print. Ended up needing one that rises as well, but will use them later for sure.

Printed perfectly first try, no issues

overall quick and easy print, and helps when I'm a bit sloppy applying grease