absolutely wonderful! Fits the kids fantastic. used Double Sided tape instead of screws. Did end up using a Negitive object to trim down the sides of one of the small ones to use with the smallest lids as the design caused them to lift upwards a bit and not sit right.

Fit super well!

holes are a bit small, had to melt them in

printed in glow in the dark PLA!

it’s perfect!

works pretty well, but the very top part was a bit weak and I managed to break it while taking it off the pegboard. still, overall pretty awesome

Works well enough, but u feel like the same concept could be done with a lot less material. Like two loops for each stem, and then braces around, cutting out most of the inner material. regardless, those does work.

Used 14.2mm and it fit perfectly. Printed on A1 Mini with 0.4mm nozzle.

Printed well, installed ok, works quite well! Remember to use something like PTFE to help with movement. Also remember to “measure twice cut once” as it were; I measured and thought I had them close enough so the roll would not fall out when moved all the way to one side. nope. Oops. Moved it ~15mm closer and that did the trick!

Fantastic model. Printed a small army in Bambu Translucent PETG Blue. Printed them with no infil, just walls, so hollow inside.

Perfect!

Didn’t quite fit perfectly, wish the taper was a bit more, but it DID technically fit, even if it kept falling out.

Works pretty well, but I feel like I will have to test it more with the larger tools.

Useful for testing other Skadis prints

Worked great!

Printed super tiny versions (scaled down from base model) in Bambu translucent PETG. super cute! Added a bit of paint to help them pop a bit.

simple but worked ok

Printed in Bambu Glow PLA. Printed one version with the base (not pictured) and one without the base (picture). I do not suggest printing without the base, as now it just wobbles all over. That’s my bad, not the designer’s fault.

Printed both sizes, but the larger size fit on both my Drill (PSBDD01) and Impact (PSBID01). (Smaller size did not fit either)

Printed great, worked perfectly.