Search models, users, collections, and posts
A1/Mini AMS Plug
IP Report
Print Profile(4)
Original, 0.2mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
0.28mm layer // 2 walls // 15% infill
8 min
1 plate
0.24mm layer / 2 walls / 15% infill
9 min
1 plate
HQ / 0.16mm layer / 2 walls / 15% infill
12 min
1 plate
Open in Bambu Studio
Boost
1860
4730
1374
238
9.4 k
3.3 k
Released
Description
This little plug is super easy to make and takes less than 10 min to print!
Do you have an A1/Mini and don't have the AMS system? You might notice the little black nubs where the PTFE tubes connect to the hot end vibrate and make noise during pre-print. This plug will stop the vibrating and keep dust out of them!
If you want to make sure your plug is perfectly flat, printing with a brim should work.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1374)