works great, prints easy, but make sure you’re dialed in, the overhangs can get extreme.

scales great! just need to reorient. nice print.

scales easily to use on bigger wipes. the paint remover wipes latches always fall off. this was perfect!

Revised to 4 stars; Object must be printed on its side. max qty is 2 per plate if printing more than two; object needs to be printed in a vertical position upside down with supports.

finally finishing a project I started a year ago. But this time I have upgrades and more bearings. PSA: Make sure you have plenty of bearings on hand when you decide to print this. Great tool though.

Printed great, have not needed them yet. I will report back, I can attest to them snapping together and fitting in the AMS.

Printed fine, I printed mine in ABS since there is a possibility it may be used on a roll of a High temp filament. I would rather ensure I have all temps covered with spools and adapters.

prints ok, due to the lightweight design, it’s very easy to warp the thin plastic when removing from plate. allow to cool 100% before removing or you will have a dive bomber for a plane.

Printed great! I will update the review once I've wired them up and installed hardware.

No issues with the print or functionality.

printed well, scales easily; the horns don’t fit well on the headband, the notch should be curved like the headband.

Update: the difference between wet filament and dry filament, incredibly different dimensions making them very stiff. I reprinted them with dry filament and exact setting, night and day. extremely stiff! I highly advise against the use of “silk” filaments. Silk filaments will be more prone to breaking when trying to free the joints after printing. when printed in normal PLA, the joints are still very stiff and require significant force to free the joints. Once you free them, I also suggest CAREFULLY flame polishing the joints to eliminate any areas that could cause hang-ups. Positive note, these are perfect for kids over 4, and some adults.