Looks great, my only complaintg is that the magnets are fiddly to insert and the whole thing is quite flimsy and can fall apart very easily but hey it's pretty easy to put back together again. I printed in PLA Matte and looks really good.

Good little Pi case. I had to reprint due to my fillament being wet. The first one didn't look good and was stringing. I also moved the seems to the back which I think gives better strength to the little fins that broke easily on the first print.

i printed without supports which wasn't a good idea and ended up with a lot of stringing but since this is a functional print I simply applied epoxy to hold things together and it works great. I have to say that for drying a few 100g of desecant takes under 2 hours, which is great!

Came out great, I decided to go all fancy and make the shaft from PAHT-CF which will probably wear the PLA parts down over time but hey, we'll see.

Turned out great in ABS using 0.2 Nozzle and took around 4 hours to print and needed a little bit of Bambu Adhesive to keep the small lettering attached to the plate for the first layer. There was also a little bit of bleeding of the colours but that could probably be avoided with a prime tower. I'm not so fussed on a functional print though. Nice model.

Came out great using PA6-GF, I wanted to use nylon for its heat resistant properties which is probably overkill given that it is behind the heating element but was also an excuse to see how good PA6-GF actually prints. It also adds some weight, given the density of the material which feels very solid and sturdy. I've included the print profile for those who wish to try this out. The supports came off easily as long as you take them off within 2 hours of the print finishing.

Printed in ABS and came out fine. I already used it to fill dessicant balls into dessicant holder spool inserts. Nice

Came out fairly well, a few minor imperfections but then again I was using ABS so probably would print better in PETG.

Easy to print in around 25mins and super useful. Fits the can and lid perfectly. Here in beige ABS

This is a great idea, having these to hand means that I am more inclined to use them every day. I did a few mods such as add a label holder so that I could customise this for myself and my partner.

Really userful and I extended the model a bit to fit my larger spool. Only constructive feedback would be to flip the short side so that the finish is even on both sides so that it is facing down to take on the plate texture. I only noticed after printing the first one and feel the second one looks so much nicer. I also used brass inserts to better accommodate the screws

Came out great and I even made a remix that fit a custom case I made thanks