Search models, users, collections, and posts
Achievements
Pioneer Maker
Print successful 138 different models and 1,523 hours
MakerWorld Guardian
This badge has expired
Spent quite a few hours working on finding the best settings possible for effect plates. There are a few other settings out there, some running way more initial layer flow but what they tend not to mention is that the extra flow rate also increases the thickness of the piece and causes ridges and bumps to appear further up in the layer lines causing poor quality when using somewhat thin pieces. Overall, these were the best settings i've found to use on both my A1 and my P1S.
PLA Effect Plate Settings
20
63
Share
1
0
0
Printed 4 of these. After the first one i ended up modifying the print a bit because the black background piece is excessively large for what it is. Other than that, good piece.
Share
0
0
0
2nd print of this I've done. great both times.
Share
0
0
0
Share
0
0
0
great design. my settings may be a tiny bit off as one side had a bit of a roughness to it from the layer overhang.
Share
0
0
0
wish there was instructions, printed bits that weren't needed and the spinning despite using grease isn't very good. would benefit from increasing the tolerance on the tower and changing bottom piece to TPU to get better grip on counter. beyond all of that, it's a decent design and useful to get them out of a jar.
Share
0
0
0
fast spools, very nice. Just be cautious putting these in a dryer near thier help temp.
Share
0
0
0
works well, but the numbers can be a little hard to read even with a black outside and white numbers. and the "1" also got a bit wonky. I'd suggest bringing the white forward a bit instead of so deep on the inlay.
Share
0
0
0
printed really well in blue with metal flake. made one for pens and made a bigger one for the kitchen.
Share
0
0
0
worked great. printed in PLA and strapped them to a new refill for other pla and tossed them in the dryer. They got deformed but that's a me problem for not thinking about the heat.
Share
0
0
0
smooth all around. tree popped off super easy and the stencils are good. only critique would be some sort of catch to prevent all of the stencils from sliding out but I'm not sure that would even work. 5 of 5. Great print.
Share
0
0
0
No more data