I printed on a smooth plate and the pieces ended up fusing together on the first layer. I think this was my fault for using the smooth plate. a few taps with the handle of my pliers and it was all good. I wonder if the first layer was slightly smaller where the pieces connect if it would have still fused.

printed perfectly

printed great!

printed great, I wasn’t paying attention to the size and was quite surprised by how large it is. none the less, my niece and nephew love it

Great print! I wish the assembly instructions were a bit slower. The animation is cool but there is so much happening it is hard to figure out

printed great, my only complaint is that my daughter wants a million of them now

great print!

Stunning print

Great print! I love having a spot for everything. If you are hunting for a handle for this, please check out my model here: https://makerworld.com/en/models/1335097-short-handle-for-the-toolbox-ams-riser-drawer#profileId-1374206

Excellent model and print! Great work ElleDee! If you want it to be a bit taller, I remixed the plates to make height extensions that are 120mm, 160mm, and 200mm. https://makerworld.com/en/models/1333954-extension-for-infinite-skadis-120mm-160mm-200mm#profileId-1372873

printed great and work well with my pliers

great print!

printed perfectly and the supports can of nicely. makes it much easier to align the plate!

no issues, came out great

printed perfectly

Great print! fits perfectly

it printed great and my daughter is thrilled!