I've tried a couple different filament clips and found these to work the best without bending the ends such that I need to trim off the damaged end so it doesn't hang up in the printer. Printed them in red so they stand out against the rest of the filament colors making them easier to find. Guess I might need to print one in white for my red spool.

These were the perfect fit for the floating shelves in my office. They fit almost like they were designed to go here. Spent the past 3 days printing all the shelves, tops and connectors and finally have a great place to store my filament. Great model!

Printed out perfectly on my P1S on the first try. So fun to play with.

Absolutely love this model. I've printed 2 of them so far (1 small in black and blue and 1 large in black and red) and they've both turned out beautifully. Can't wait to print more to give as gifts to family.

It took a while to print, but it was worth it. The pieces all fit together perfectly and once installed under my P1S is looks like it's part of the printer. Great model and well worth it.

Great model and it fits in the Lumos perfectly. My first print wasn't great because I ignored the warning in Bambu Studio about printing it with supports and so I suffered the consequences. 2nd print with supports came out great. When BS tells you to print with supports, that's no BS. Lesson learned. :)

Quick and simple to print, but so useful for measuring. I forgot to add a pause so I could swap the filament to a different color so I had to use a Sharpie, but that's on me, not the model. :)

Easy and quick to print and fit perfectly in the drawer/

Perfect fit and easy installation. Saves me from a ton of frustration aligning the print plate.

This fit perfectly in my desk hole. Great model!

printed cleanly and assembled pretty well. the only issue I had is with the small nub you use to wind it up not wanting to fit on the shaft all the way. it should still work though. also, the turning is a bit tough, but I’m guessing it will turn more freely once it has worn down a groove. good print all in all.

This printed out perfectly the first time and now I’m ready to get my grid printing on.

good design, though I will probably scale it up a little the next time I print it as it is a bit small/loose in the 50 mm hole I drilled in my desk.

this was my first print on my new P1S and it worked perfectly.