This turned out really well! Thanks!

I printed it really small for use in Heroquest

This helped keep some loose filament together. Nicely done.

I used these in a rancor monster print.

This printed well. It is not too large at this scale for dnd.

At a smaller scale some of the detail is lost but for a basic figure it went well. A smaller nozzle might have helped. A .2mm would likely have helped a lot.

I will try to update this review with a painted version. I added a chain for more of a movie like appearance. I thought this was a great and easy overall print and, if your patient, a not too difficult support removal.

I shrank your chain down to fit a rancor monster! Thanks!

I thought these were too cool to not print. I thought I would use them as a reward in Heroquest.

This printed really nice. Haven't tested it in the real store but it seems strong enough to hold up.

I spray painted mine gold and it really pops in the system. Sorry for the blurry picture but it really does look nice.

It clicks and snaps together really nicely. Good job!

I used this guy's tutorial and I think it worked really well. https://www.youtube.com/watch?v=n5LHoHvPDtk&t=19s

This turned out really well. Thank you!

They came out great! Thanks.

it came up about short on my p1s while the ride side fit well the left seemed a couple of mm’s short