prints perfectly with PETG but I'm having hard time with ABS. Top containers warped heavily on the bottom sides, but mesh resulted with no artefacts. whereas bottom containers, that had brim added to minimize warping, dripped ugly - any clue what's wrong and how to fix it? Two different ABS filaments.

perfect

Thank you

Thank you, great print 🫶

Does its job 👍

Thanks!

Removal of the supports is satisfying. Always have a bunch of them at hand.

You have to remember that dot in "i" needs to be attached to the decorations 😅

Just as other profiles and sizes - works as a charm.

Slightly modified to be only single holder and also uploaded as a new print profile 👍

Good print and model in overall. But I feel like it could fit 22-23 samples with a bit of tweaking the gaps. The samples have a lot of play in the slots, it could be reduced a bit, together with width of the walls. Print seems to be heavy and sturdy, maybe even too sturdy for what it serves :)

Shaded top makes the non-uniform effect when using LED. Other profile for comparison.

PLA Matte I didn't care about the time, so decided to print horizontally with PETG as interface support. oh boy, the additional filament usage was totally worth it while removing the supports, totally satisfactory experience 😁 Experienced some warping on all 4 edges though, even though I thoroughly cleaned the plate, used glue and raised bed temp to 65 🤷‍♂️ Started around 3 hours after start (12h print)

excellent print and fit

PLA Matte. One support broke (under a claw), but still turned out great. Now printing 2 more, this time with 50% speed only, will see the results in the morning.

ABS, excellent fit, tight - you have to use significant amount of force to install the meter, but not too tight