prints nice and is a nice size.

Both designs have printed near flawlessly. my trouble was with the Spool of red pla from Bambu, keeps wanting to unspool from the inside. Prints however look great! Wife is excited about them. Nice Work on the Models!

Prints as expected! The only thing I would do differently is to maybe tilt the angle on the radius a little more to get the lights pointing in a slightly best position. That way it’s like a banking on a race track. However, these work great and do the job as you would expect.

printed fine and as expected. the sliders did need so work to get them to slide. but it all fits together good. I think the supports could probably be tweaked just a bit to make easier digging out the slots. but it prints and works as intended. thanks for the file!

Printed Great! With my light, it was a little wobbly and fiddly until I got it situated and locked in. but they stand up and just the right height. Thanks!

Printed Clean and sturdy.

Printed Great. hardly and clean up. maybe a few edges with the deburring tool. Not sure what the little spacers are for, are they feet or standoffs? Regardless, printed great, fitment was great. Hold ATX solid. Just need a way to clip the plate to the Body for moving or storage. Thanks for the print!

Printed Clean. next one I’ll print larger for bigger effects. Thanks!

Printed 4 , printed as expected. small clean up on plate end from brim. Slide right on and hold tight.

Printed great, except for spin, mine fussed. but it’s fine. works as expected. (also note for users this is for a no frame aquarium top. I neglected to see that. )

prints as expected. tool heads snap in and hold nicely.

These print as expected and add a nice touch and height to the platform.

Very cool model(s)! Printed as a smaller vignette option for 6” Sci-Fi figure dioramas or desk top item. These print very well and the fitment is great. I used a small amount of weld on 4 to glue the back panels together and them to the bottom for structure. Left the top unglued. Thank you for the model!

Prints great in PLA.

Nice! prints as expected. Holds great. I used Weld-on instead of Supr Glu.

Fits my files great. prints smoothly and very little clean up.