Super cute print. I cut a hole on the sides to add glass eyes. Printed with silk. Thanks

Super cute print, no problem at .16mm layer height. Printed with sakura pink, and added some glass eyes. Only thing that should be improved is the hole position, i'm quite sure the point is going to break.

Cute design, but can be improved. One of the cats should be mirrored. This way if you print on a smooth plate at least you get a nice symmetry. I printed with a .4 nozzle and the result was ok.

Printed with only one color since i just wanted the scare/fly effect. Printed fine no problems. But it's not flying at all... I used the right bands from Bambu lab and even when winding up like 30 - 50 or more or less times and it's not spinning much (tried one and two bands too). It jumps a bit and that's it.

Printed just ok with a 0.2mm nozzle, looks nicer on the bed face. The model is simple but nice. No problems with the hole size.

Fast and easy print, not using too much filament and does the job. I got a warning message saying the model is not manifold or something like that. But it worked anyway.

The design is cute, but doesn't print perfectly. My plate was cleaned and the filament calibrated. But some parts of the intricate design can be missing with a .4mm nozzle. Can be improved a bit.

A nice and easy print. We can see some overhangs when inspecting the inside loops, but it's not noticeable from outside, and it's not doing any harm to the flex, i printed the separate parts to not waste any filament, and just glued the eyes after. A beautiful design. Thank you

Superb print, i used part of the print (the part to straighten the ptfe tubes) since i positioned my ams at the back, and it worked nicely, just the right fit.

Printed nicely, the design is a bit too "fat", but no problems with the profile

A super cute model. Printed nicely on A1 with PLA, only things i would change : reduce the % infill, no need for so much filament... And the model should be modified to avoid the tree support on the lower paw. Other than that it's a cool model.

Sweet design, but the profile is not perfect, the infill lines width are not adjusted, so some holes are visible (top and bottom surface even with the ironing). I had to tweak and adjust at least 3 times the lines width to get something that was okay. See the original print bottom surface (my flow and filaments are correctly adjusted so it's really a design/profile problem). I'm not giving a lower rate to be supportive but adjusting the line width is advised.

Printed nicely, the two parts of the spool are coming together like they should. And i appreciate the fact that i don't need to waste too much filament for a reusable spool. Thanks for the modifier.

Printed just fine, the hole is tight but not a problem to insert the filament (it's even better to avoid any accidental release

Printed nicely, the hole is a bit tight but was ok. The shape can be a bit fragile, beware when removing the print.

Prints ok but i got some problems with the hinge : it fused. Maybe it's due to the overhang/bridge. Lowering the speed should help. But i can still use the clip since the shape is bending a bit and not breaking so...

A nice fit, but can break when inserting the cable if you use pla. Good

Fit's nicely to the base, but the coil break easily with PLA, i broke one just trying to insert the cable.

A super fun design, it does fly, but it's super fragile (broke almost instantly) fun anyway

It's a nice model, the bottom face doesn't look good, but not much that can be done to improve it anyway.