very cool design. I've printe the diffuser in glow-in-the-dark filament.

had to print several of them because I keep giving them away

I printed it on PETG, but it has to be extra dry as the wall is too thin

it is awesome, but it is very difficult to make it move properly. some axis have too much friction. it would have been better if the axis were slightly thicker to allow for some smoothing by sanding. also, doesn’t matter the length of the pendulum, I can’t make it slow enough to run accurately. apart from that, when it works, the tick tack is very relaxing; perfect for meditation

I have perfect eyesight, but my wife said that she can read text better in the distance. maybe smaller holes will be better for the farsighted people as it can better simulate a pinhole “lens”.

printing the inner side failed twice. the first time it was an adhesion issue, the second time, after properly cleaning the build plate, the same issue happened. the third print was successful, but the overhangs look terrible. but the whole thing is very useful. will print it again.

very good fit. I’d print it again, but I only have 1 car 😃

it is a very clever design, but one significant improvement could be to have the bottom shelf and lip, where the bottom of the can rests, to be curved so it will better hold the bottom of the can. I know you sacrifice the ability to hold the locking ring, but it might hold the can more securely. I especially like that to add strength you added the through holes; and the clip to be printed laying down so there won’t be supports and z-layer delamination.

Sort of flies, but you need speed and technique. in the garden it becomes a lawn dart.

Súper strong vise even with PLA. Will print it again. My only criticism is the bottom screw section with the spinning head. Because it rotates freely, when you unscrew it from the desk, the spinning head also unscrews.

I’ve printed it two times the whole set, one at 100% and another at 50%. The food one is perfect, but the water one leaks somewhere. It should be printed at 100% infill, but with a slightly thinner base. Apart from that, my chick loves it. excellent fit even when scaled.

perfect for my needs. I only added a negative volume modifier as I needed to thread a ribbon and not a cord.

I liked the model, and the accessories, but I read too fast the instructions and forgot to add the screw, so the axel broke immediately.

they look very nice, but I think I haven’t set the volumetric extrusion high enough, and the textured PEI plate doesn’t leave a nice texture for these earrings.

I printed it at 50% on the X and Y directions and I left the Z to 100%. I recommend the model, but not my settings 😀