The outer rings don't spin as freely as the inner ones.

Works great, adds functionality you can't buy from Gravitrax.

Works great. The chains are a little fiddly and fairly stiff, but I didn't have any break. Just make sure you're not pulling on the chain to remove the supports, but instead flexing the support areas underneath to break them off.

Works great. As others have found, only fits 4 Bambu spools.

The wings do not flex at all and are rigidly connected to the head. Would be a great improvement to have them on separate joints.

Appreciate having separate eye parts for non AMS multicolour.

Appreciate having separate eye parts for non AMS multicolour.

Appreciate having separate eye parts for non AMS multicolour. Adds a lot.

Prints well. There's a slight bobble on the right side of the bunny (left side in the images) just above the hind leg. I guess this is an artifact from the image-to-3d process used. Really appreciate that the "No POOPS, No AMS" has the eyes separated out to have alternate colours without using an AMS.

As in the model description, it's from Sketchfab and there's a few elements that stick out as not having been designed for printing (needs supports for the small gap under the claws etc. That said it looks good and prints well.

Head is a little loose and flops to the side a bit but it prints well.

Great print, very flexible and fun to coil around.

Works great. Printed in PLA - may try PETG for it's extra flex for the spring to see if that makes the action and trigger smoother and easier, especially for young kids.

I printed 2 on the same plate. One came out great, the hole for the filament on the other was a little too narrow on the side that was on the plate.

Prints great, nice smooth flex to it.

Great print, the supports on the standing version leave a bit of roughness on the underside.

Make sure you use a smooth plate.

Have to be very careful with the pins and the actual movement is a little awkward and stiff.

Great Deaign.