changed the layer height to 0.16 optimal and it turned out great

You saved lives from vanishing 5 stars isn't enough to thank you

the Gears jam easily even after sanding axels and lubricating everything everything printed using SUNLU PETG

works great but it's a little bit hard for kids (a lot of air leaking need to be compensate by a powerful blow) making a smaller model will be extra perfect.

still requires sanding

it's very good but the support is not needed at all

I use it to check ambient temperature around the plate to know how to adjust my printer settings an earned boost for that, thank you.

It bites so hard, it's a crocodile after all 🤣

Better than Titanic it floats, unsinkable. Had no opportunity to take a picture of it before my toddler took it for test

Good finish but it may break if over tested

It do it job very well

it turned out great !!

It didn't go well in the first attempt due to bed temperature drop (cold weather) i upscaled the bed temperature to 72° and it turned out good

a very good and robust print