13 Deadpool (No AMS Required)

Modified from the official version #13 released by the esteemed soozafone. Every effort was made to preserve the original artist's aesthetic. The Deadpool likeness is primarily based on his portrayal in Marvel films.

Regarding the supports, Shadymilkman's supports were slightly reduced in size because the print dimensions were somewhat large for my mini—I wanted to print four at once.

For the weapon pack, the size of the back sheath on mystoopidstuff's pack was adjusted to securely hold the blades, and the thigh holsters were completely redesigned.

Magnetic mounts are incorporated into both the buttocks and legs. The buttocks use a 6mm diameter, 3mm high cylindrical magnet; the feet employ a 5mm diameter, 3mm high cylindrical magnet.
Printed using an A1 MINI, the armor sections utilized a 0.2 nozzle with 0.08mm precision for flawless results. Maintaining the model's print orientation is advisable to optimize aesthetics and component strength.

The skeleton was printed with a 0.4 nozzle at 0.2mm precision. The print order for some models was modified to outer walls first, then inner walls.

Other Marvel Characters

Captain America #13 Remix - By 啪啪侠 - MakerWorld

Wolverine #13 (No AMS Required) Remix - By 啪啪侠 - MakerWorld

Iron Man #13 (No AMS Required) Remix - By 啪啪侠 - MakerWorld

Additional Notes

The thigh holsters must be attached before the lower legs.

For optimal results, press the eyes firmly onto a flat surface, as illustrated below.

The correctly installed eyes should protrude only slightly above the face, as shown.