Printed in black PLA with my own profile. It fits very good and seals quite tight. A very good replacement for the original lid. Thank you very much.

Printed in White PLA without any issues. Works very well.

Printed with silver PETG. I'm definitely going to use them at Christmas.

Printed with PLA, good fit, easy to use.

Printed in SUNLU PLA+ White. I needed to resize it for Volvic-Bottles (37 mm). The first attempt was a little bit too loose, the second one was a good fit. The round shape works well and takes up very little storage space.

Printed using SUNLU PLA+ White. I really like this design because I don't have to permanently install the Allen key. I can remove it from the handle when needed.

Printed in SUNLU PETG black without any problems and attached with double-sided adhesive tape. I use the 3-slot version most often, as I often need to connect 1-2 cables and still have at least one more slot available if necessary.

The first print didn't work because only uniform scaling is possible. I obviously overlooked that. The second print turned out very well. The dimensions fit and it looks just awesome. But now I have to somehow fit a rectangular image into a square frame. I'm looking forward to using the customizable version, which will hopefully support a rectangular frame. (Printed using SUNLU PLA+ White)

Printed in black PETG, but had to resize it to 101% because I didn't want to use both hands the get if off the stand. But that's just a personal preference.

Printed in black PETG without any issues. That's a fine tweezer which I can use for magnets.

Printed in black PETG. Works just fine and is small enough to fit into my also printed bit box. I'm going to print some more of both to spread them around the house.

Printed in black and gray PETG. Would have been a flawless print, if my filament would have been dry enough. Luckily there was only one bad spot and the latch covers it perfectly. :-)

Printed in PETG in black and gray without any issues. The lid fits, but I'd like to see an updated version with some kind of snap fit lid though.

Printed in PETG, black with a white top layer. Great for finally tidying up my collection of “miscellaneous screws.” Not really satisfied with the text. Maybe I'll print another one in black with a white top layer, as the text looks blurry. Or I'll try an even smaller layer height or nozzle. I'm not that experienced with printing text as I don't have AMS.

Printed with black PETG, using the two-part version, which I glued together at the end. I surprised my wife by secretly putting it in the book she is currently reading. She was very happy about it, especially since it's unique and looks really great.

Das Profil druckte sich einwandfrei in PLA. Zur Sicherheit habe ich noch ein paar Mausohren angebracht, da mir die letzten paar Drucke eigener Designs, die höher als breit waren, beim Drucken Probleme mit der Betthaftung boten. Der Support ließ sich leicht entfernen, die Mausohren auch und es gab nur ganz wenig Nacharbeit. Das Anbringen am A1 mini ging schnell und problemlos. Erst als ich die PTFE Schläuche abzog, bemerkte ich, daß die Einheit dort wohl Zugkräften ausgesetzt war, denen ich gar nicht bewußt war. Nun sieht das viel besser aus. Vielen Dank für das Design.

The clip printed well, but the ball was a disaster, more like a football than a sphere. After sanding, it worked fine, but I think next time I'll print them separately or try to get 15 mm balls made of wood or a similar material. I'm new to 3D printing and this was my first attempt at printing any kind of ball, so I may be doing something wrong. If anyone has any idea what might have gone wrong, I'd appreciate a tip.